The following steps should be strictly carried out when the conveyor is driven by electric roller. If there are any differences, seek professional help to avoid unknown problems. At the same time, it should be operated correctly to reduce the possibility of equipment failure. Of course, don't forget to take good maintenance measures, which can only extend the service life of the equipment, but also avoid danger.

Installation method of electric roller:

1. The roller should be in horizontal position. The conveyor belt should match the installation size of the electric roller. The installed electric roller shall be firm reliable, the roller shall be placed horizontally. The inclination angle should be less than 5 degrees.

2. Place the pin as close as possible to the contact surface between the box the base under the pinion shaft to reduce the thermal deformation caused by the high-speed shaft.

3. The cooling lubricant should be injected before the operation of the electric drum. The cooling lubricant is injected into the drum through the oil injection hole, the height of the oil surface is L / 3 of the drum diameter.

4. The connection between the drum the power supply should be firm, the ground wire should be firmly connected to the ground wire post in the junction box, the body shell should be correctly grounded. Protect the equipment check whether it meets the requirements of the roller name plate.

5. The temperature sensor should be close to the bearing of the bearing as far as possible. In order to measure the vibration requirement of shaft, the arrangement of vibration probe should be considered in bearing box.

(1) tank planning should enable the lubricant to be discharged as soon as possible reduce the formation of foam. Bearings oil seals shall be reserved between shafts, the back oil in the box shall meet the requirements of lubricating oil dredging of passage bearing, so as to avoid lubricant bubble leakage through shaft seal.

(2) Two different methods are used to fix the roller bearing. One case cover is pressed on the bearing to bear the load bearing; the other is to install the bearing cover in the box accept the full bearing capacity. The lid can be made thinner for maintenance sealing effect.

This support, also known as roller shoe roller bearing pedestal in some areas, is usually made of hard brittle gray cast iron. In the process of lifting, it may be damaged due to the collision falling of the electric drum. Roller casting surface, whether it is electric roller driving roller reversing roller, can be made into rubber coating roller tape casting rubber roller according to the needs of users. In the process of logistics transportation, the rubber surface is relative to the steel roll bearing seat. Parts are more likely to break. The end cover of TDY oil cooled electric drum the internal components on the surface of the cylinder are usually damaged when they fall during the lifting process, resulting in the collapse of the cylinder surface the damage of the internal drum gear. The junction box of the electric roller junction box, especially the junction box, is made of cast iron, the connection position is very thin, the junction box protrudes the roller.